SOLUS
in silver
£375.00 free
P&P
In Black £375.00 free
P&P
Overview
The Solus is our one of our entry level 6-way filters which has
the option of upgrade to the more sophisticated Mini Sub. The
Solus was designed to be a very rewarding single box ‘plug-n-play’
solution for a complete audio or home theatre system. Using our
advanced ‘Polaris-X’ technology the Solus is able
to draw mains contaminants away from audio components plugged
into the unit.
All components featured in the Solus are of the highest grade
and are under stressed, this gives greater longevity, which are
then hand soldered onto the PCB with silver solder.
Safety
In the interest of safety the unit should be placed upon its own
dedicated shelf on an audio grade equipment rack. The unit may be
placed on top of or under other pieces of equipment, do not exceed
a maximum weight loading of 20kg.
Do not place the Solus in areas where the temperature is likely
to exceed 25 degrees. For example, close proximity to ‘tube’
amplifiers.
If you have to locate the unit on the floor we strongly recommend
you do not place the unit near heat sources, such as radiators or
air ducts. Good air circulation is essential to prevent heat build
up within the chassis. Do not place the Solus on a soft surface,
for example a rug or carpet, which could block the ventilation intakes
on the underside of the unit. Do not let any liquids spill onto
or objects fall into the chassis. Should either of these events
happen, immediately switch off the unit at the wall socket, wait
for at least one minute, unplug all other cables and return it to
your authorised IsoTek dealer for a full service.
Placement
Ideally the unit should be placed upon its own dedicated shelf of
an audio grade equipment rack. If this is not possible the unit
may be placed on top of or under other pieces of equipment to a
maximum weight limit of 20kg. Due to the products careful screening
by way of a large ground plane within the unit, no adverse effects
should be caused by this placement. If you have to locate the unit
on the floor or in any other location please refer to the safety
section of this manual.
Equipment
coupling
Once the Solus is safely positioned connect the unit to a mains
wall socket, we recommend that a good quality cable is used and
that the wall socket is also unswitched. Turn off all equipment
you wish to have a clean mains supply, unplug the cables relating
to these from the wall socket or redundant distribution block you
may have been using and plug these into the rear sockets of the
Solus. All of the Soluss Outputs are the same high power rating
and can be used for all devices. This is subject to the total power
consumption being less than 2.4kw.
System
integration
We strongly recommend that a good quality mains cable is used and
this cable is consistent throughout your system. Look for a cable
with good conductors, for example oxygen free copper, this cable
should also have a high degree of shielding from RFI.
Specifications
The following information relates only to the IsoTek GII Solus.
These are original products and should not be confused with previous
or ‘copy cat’ models.
Number
of outlets: 6
Type of outlets: 13A UK unswitched
Standard mains inlet: IEC fused
Mains voltage: 190 - 260VAC
Maximum current
(typical to location used) 13 Amps (UK)
Total maximum current: 18 Amps
External mains fuse: 6.3 Amps (13Amps UK)
Dimensions: 444mm x 85mm x 305mm (WxHxD)
Weight (boxed): 6.0Kg
|
