e.One REF1000 - 1000 watt mono block amplifier


£1,799.00
Free P&P in UK

The audio amplifier is the engine of the audio system. It must provide the power to drive the loudspeaker motor. The amplifier has huge power gain: from micro-watts of input power to 100’s of watts of output power the audio amplifier must do its job with ease and competence.

Key issues that must be addressed in a high performance audio amplifier are:

Power supply design defines the performance limit of the amplifier, fully regulated power supplies provide the standard for fidelity. True balanced operation improves the signal fidelity under load.
Balanced input insures that the large output/input power ratio does not corrupt the input signal fidelity. Low output stage impedance, especially at low frequencies, insures maximum control of the loudspeaker driver. Comprehensive protection circuit that is outside the signal path is critical to protecting both the amplifier and loudspeaker. A short, simple, signal path with a minimum of output devices leads to a better audio performance.

All of the Bel Canto e.One amplifiers are designed to optimize performance of all of these criteria. The REF1000 represents the summit of audio amplifier performance with over 1000 watts of low-distortion, wide-band power available, fully regulated switching power supply, true balanced operation, 2 ohm drive and 120dB of dynamic range capability. Your audio system performance will reach extreme levels with the REF1000.

With REF1000s in your system it will sound like you are connected directly to the music source, the loudspeaker and amplifier effectively disappear in the large and compelling sonic picture. Fidelity and signal clarity is unmatched from the lowest audio frequencies through to the sweetest high frequencies. The utter mid-range clarity especially allows the music to communicate as never before.

Discover what this remarkable amplifier technology can do for your audio system.

e.One REF1000 Specifications
Power Output: >1000W into 4 ohms, >500W into 8 ohms
Minimum Load: 2 ohms
Frequency Response: +/-0.5dB 20Hz-20KHz, all loads
THD+N: 0.007% 1W, 1KHz, 4 ohms
IMD (CCIF): 0.0007%, 1W, 14:15KHz, 4 ohms
Output noise: 90uVRMS A-weighted 10Hz-20KHz
Voltage gain: 27dB (single ended or balanced input)
Damping factor: >1000
Output Impedance at 100Hz <8 milliohms
Dynamic Range: 120dB
Input Voltage for Max Output 3Vrms
Input connections: Single-ended RCA or balanced XLR
RCA input impedance: 10Kohms
Balanced input impedance: 20Kohms
Output connections: 1-set WBT 5-way safety binding posts
Standby Power: 15W
Size: 8.5x3x12[inches], 216x76x305[mm] (WxHxD)
Weight: 13lbs, 6Kg

Features and specifications are subject to improvements and changes without prior notice

visit the website design guide